jæja þá er maður loksins orðinn sæmilega vel settur peningalega og getur farið að eyða.. hehe

hérna þetta er það sem ég er að fara að fá mér næst og er ég að fara að ná í það út í USA 16 ágúst næstkomandi..

Þetta er semsagt aguilar OPB-3 formagnari og DiMarzio Model P/J pickuppar..

Specs fyrir formagnara.

2 Pickup - 4 knob / 1 switch Configuration

Vol - Blend - Mid - Treble/Bass Stack Pots, Mid selector switch

Replace Mid Selector Switch with Push/Pull on Mid Pot

Add Active/Passive Switch

OBP3 Pre-wired and Tested (18 Volt)

Aguilar OBP-3 Bass Preamp Description

The Aguilar OBP3 was built from the ground up to be the ultimate source of full-bodied tone, transparency, and versatility for your bass.

Three bands of boost/cut and a selectable midrange frequency provides flexibility to dial in just the right tone. The treble control delivers up to 16dB of boost/cut at 6.5Hz and captures the dynamic of a “Passive Tone Control” when rolled off. The powerful midrange control offers user selectable frequencies of 400 or 800Hz, each with a full 16dB boost/cut capability. The midrange retains constant bandwidth in any setting so there is no “muddy” frequency overlap. The bass control features a boost/cut of up to 18dB at 40Hz, adding Aguilar's signature thickness to any instrument.

The Aguilar OBP3 is compatible with most major manufacturer�s pickups, and its small size makes it an easy retrofit in almost any bass. Combining high headroom and low noise, the OBP-3 is unmatched in providing tonal flexibility while retaining the true character of any bass!

Specifications:

Bass control: plus/minus 18 dB @ 40 Hz.
Mid control: plus/minus 16 dB @ 400Hz or 800 Hz. User selectable frequency center.
Treble control: plus/minus 16 dB @ 6.5 KHz.

Input impedance: 1 meg ohm
Output impedance: 100 ohm
9, 18 or 27 volts operation. Additional 6dB headroom with 18 volts…additional 3.5 db headroom with 27.

Distortion: .019 into 10k ohm load
Noise -95 dBm unweighted.
Battery life: 324 hours
Wire lead length: 6.50 inches

Low noise discrete FET input stage, center detent 50 K linear pots,with a dual concentric pot available.

Dimensions: 0.98“W x 0.98”L x 0.59"D

Ten year limited warranty.


Specs fyrir P/J pickuppa

Model P Specs
Breathe new life into any bass by replacing its stock pickup with a DiMarzio Model P. This hum-cancelling two-piece pickup brings big, punchy sound to FENDER PRECISION BASS� style pickups. The DiMarzio Model P accurately reproduces the sound of your bass with added gain and solid tone. DiMarzio Model P pickups cut through the band without sacrificing bottom-end power. Gutsy mid-range provides growl when the bass is pushed hard. Combine the DiMarzio Model P� with a bridge position Dimarzio Model J and experience any tone from a tight mid-range punch to a warm bottom-end with bright, clear attack.

Tech Talk:
Heavy sound with midrange emphasis. Aggresive sound designed to cut through dense tracks and loud situations.

Specifications:
Wiring: Standard four conductor
Magnet: Ceramic
Output: 163mV
DC Resistance: 11.3K
Year of introduction: 1977

Model J Specs
DiMarzio Model J�s keep the crunchy, focused sound of the traditional Fender Jazz Bass tone while boosting gain and response. This additional presence translates into a bigger sound with improved attack and bite; great for highly articulated finger or pick-style playing where quick response is needed. The DiMarzio Model J� pickup's sensitivity and deep tone are also the perfect complement to the warm character of fretless basses. Double-stop glissandos and delicate violin-style vibrato speak with a classic, woody voice simply by backing off slightly on the tone controls.

Tech Talk:
Unlike traditional Js, each Model J� is individually humbucking. It's not a stack: each coil picks up one pair of strings. By doing it this way, we keep the resistance down, and the tone clean and clear.

Wiring: Standard four conductor
Magnet: Ceramic
Output: 150mV
DC Resistance: 6.73K
Year of introduction: 1979